11
Oct. 23, 2026
What Is Self-Compacting Concrete (SCC)? Mix Design, Tests and Admixtures Self-compacting concrete fills the formwork under its own weight, with no vibration. It runs on a water-binder ratio of 0.30-0.40, paste volume of 38-42% and 400-600 kg/m3 of powder, with PCE at 0.5%-1.2%. Slump flow target is 550-850 mm across classes SF1 to SF3, and L-box H2/H1 at least 0.80. Add a VMA when paste risks segregating.
Oct. 22, 2026
Why Does Less Water Make Concrete Stronger? (The Water-Cement Ratio) Only 0.23-0.25 kg of water per kg of cement is needed for hydration; the rest evaporates and leaves capillary pores, so strength falls as the water-cement ratio rises - Abrams' law. Typical w/c: 0.45-0.55 for C25-C30, 0.35-0.45 for C40-C50, 0.30-0.35 or lower for C60+. A PCE cuts mixing water 25%-35% at the same slump.
Oct. 21, 2026
Why Does Concrete Lose Slump in Hot Weather? (And How to Keep It Workable) Hot-weather slump loss is faster hydration consuming the PCE, not a weak admixture. Read the timing: stiff right after mixing means too little standard PCE, so raise the dose; fine at first then dropping after 30 minutes means you need a high slump-retention PCE at 6010:6020RT = 9:1 to 3:1. Do not reach for a retarder by default.
Oct. 20, 2026
Why Does Concrete Set Too Fast or Too Slow? (And How to Control It) Initial set is normally 2-4 hours and final set 4-10 hours, and hydration roughly doubles in speed for every 10 °C rise. Setting too fast: add a retarder at 0.05%-0.2% of cement. Too slow: add an early-strength agent. The distinction that matters most - a retarder delays set, a high slump-retention PCE holds flow without delaying it.
Oct. 19, 2026
Why Does Concrete Bleed and How to Stop It Bleeding is free water rising to the surface, not coarse aggregate separating. The usual causes are too much water, an over-dosed superplasticizer or retarder, and coarse sand. A PCE disperses by electrostatic repulsion and steric hindrance, so its side chains release water gradually - over-dosing bleeds far less than a naphthalene reducer.
Oct. 16, 2026
How to Tell a Real Polycarboxylate Superplasticizer (PCE) Tablet from Raw Macromonomer A macromonomer is the raw material for PCE, not a water reducer. Both are white solids, but a macromonomer weighs 2,400-3,000 g/mol and reduces almost no water, while a finished PCE weighs 20,000-60,000 g/mol and cuts water by 25%-40%. It is also waxy and softens in heat. One trial mix at 0.1%-0.3% settles the question.
E-mail: sdcharing@sdcharing.com
Phone: +86 131 7667 0070
WhatsApp: +8615066133527
Add.: No.605-606,NO1 BUILDING,WANGYUE ZHIGU INDUSTRY PARK,NO.1919 WANGYUE ROAD, SHIZHONG AREA,JINAN CITY, SHANDONG PROVINCE,CHINA
